4) You will need to have on hand garbage disposal tape, small gas torch, solder, flux, plumbing sandpaper, pipe cutter, gas tape (to seal gas line) and maybe some pipe glue. Ask the sales person at the hardware store for a more defined list.
When you get to the house stand if front of the toilet and locate the water shut off valve. Should be down below the toilet on the wall. Just turn it off (righty-tighty) completely and flush the toilet. All the water should have left the tank, well at least most of it. If there is remaining water line repair get it out with paper towels or a rag. The important thing is that no more water came in. If it did then your valve is not shut all the way or not working and you need additional help.
Unfortunately, people will band together to gain support on something regardless of whether or not it is true. In this case, one person shared their thoughts on how ineffective the letters are and yet, they had nothing but their opinion to support this. They found a group of willing listeners who quickly became active supporters of the belief.
Dirty waste water, after all, leaves your house following the law of gravity. Waste water goes downward to the sewer or septic tank, nice and easy. Behind this simple rule is the multitude of vents and traps to keep the process of waste removal possible. Vents allow air to fill drainpipes, precious air that allow waste water outflow. Traps are those curved S-shaped sections of the pipes under the sink drain. Traps perform a crucial role in forcing most of the water through the drainpipe, but leaving some to seal the area and prevent sewer gas from backing up.
Keep an eye on any leaks in and around the house. Inspect taps, pipes and your roof regularly. Watch for leaks and if you find them, get it water line repair as soon as possible.
Plumbers should always have a durable and long lasting ventilation system ready for any job. Having clean air in ready supply can make many tougher jobs go much more smoothly and will cut down on the risk to the plumbers considerably.
Then, you can take your new shower parts home and reinstall them in the inner assembly. It is very important that everything be aligned properly and tightened to prevent leaks. Beware of over tightening, however, since this can also cause problems. Once you are sure everything is installed properly, replace the cover plate and turn the water back on to test your repair work. With a little bit of work, your do-it-yourself shower repair project can be a success. It does not take an expert, just a little effort and know how.